RCU Forums - View Single Post - quick hex question
Thread: quick hex question
View Single Post
Old 03-10-2012 | 05:54 AM
  #1  
echthelion's Avatar
echthelion
 
Joined: Feb 2011
Posts: 493
Likes: 0
Received 2 Likes on 2 Posts
Default quick hex question
so im looking at http://www3.towerhobbies.com/cgi-bin...LXAYPF&P=M

now im alittle confused i know 5/64 and 2.0mm are not 100% the same size. im woundering if this would round out my 2.0mm screws/ tip faster then a normal 2.0mm bit
echthelion is offline  
Reply Like