Ok finally got two good starts out of it, they still seemed a little wet, and still had some flames coming out, like the batmobile as it was earlier mentioned, but not to the point where Its hurting anything.
When it was on the bench it started totally clean no flame at all. Maybe it did have some flames on the bench but since it was outside during the day i couldnt see them, this time i was in my garage.
Also when I shut it down both times after the FADEC cooled it down it gave me the flame out message. I read the manual and that represented EGT to low. turn it off turn it back on its fine,
just dont remember if that message was normal after shut down?