RCU Forums - View Single Post - OS 33GT Gasoline Engine for Pattern
View Single Post
Old 03-23-2012 | 10:15 PM
  #247  
MTK
Senior Member
 
Joined: May 2004
Posts: 5,386
Likes: 0
Received 1 Like on 1 Post
From: Whippany, NJ
Default RE: OS 33GT Gasoline Engine for Pattern

Today was the first truly warm day we have had. Temps in mid to upper 70's. Still not summer but not cold either. The barrowed 19x11 went back to its owner and I flew with the 18x10 Mezjlik 3 blade. Needles actually needed a bit of leaning...a combination of warmer weather and lower load.

Anyway, on the third run it got a little stubborn so I used the damned meat grinder on it. The cone slipped causing the front end to shake violently, damaging the nose ring set-up. Aggravating since it ruined a perfectly good flying day. Damage was minimal and has been repaired...............

My Aesthesis is absolutely a dream to fly now. It has the right amount and kind of power to make for some outstanding flying. I can't wait until the next time I get to fly. Feel like a kid again......