RCU Forums - View Single Post - removing Bowes or Warps in control surfaces?
Thread: removing Bowes or Warps in control surfaces?
View Single Post
Old 04-20-2012 | 03:31 AM
  #2  
jbdismukes
Senior Member
My Feedback: (2)
 
Joined: Sep 2004
Posts: 285
Likes: 0
Received 0 Likes on 0 Posts
From: Montgomery, AL AL
Default RE: removing Bowes or Warps in control surfaces?


Try: place it on a flat surface, bow up, heat with heat gun, press flat while letting it cool. Depending upon severity of warp/bow, that's all it takes.

Jack</p>
jbdismukes is offline  
Reply Like