RCU Forums - View Single Post - removing Bowes or Warps in control surfaces?
Thread: removing Bowes or Warps in control surfaces?
View Single Post
Old 04-20-2012 | 04:06 PM
  #7  
karolh
 
Joined: May 2002
Posts: 6,852
Received 33 Likes on 32 Posts
From: Mandeville, JAMAICA
Default RE: removing Bowes or Warps in control surfaces?
For warps like in an in aileron I prefer to use a iron rather than a heat gun, with the warped section held against a flat surface with the convex side facing up and the hot iron applied to it at approx. 350F with the piece held firmly in place until it has completely cooled.

Karol
karolh is offline  
Reply Like