RCU Forums - View Single Post - How to install a kill switch in a 6ch setup that uses already a dual elevator???
Thread: How to install a kill switch in a 6ch setup that uses already a dual elevator???
View Single Post
Old 05-26-2012 | 02:50 PM
  #3  
pilotpete2's Avatar
pilotpete2
 
Joined: Oct 2002
Posts: 3,305
Likes: 0
Received 0 Likes on 0 Posts
From: Lyndonville, VT
Default RE: How to install a kill switch in a 6ch setup that uses already a dual elevator???
AR6100 is a park flyer receiver, totally unusable in that size model with either a gas or glow engine.
You should go with an AR7000, that will allow you to run independent channels for the ailerons and elevators and a free channel for the ignition kill.
Pete
pilotpete2 is offline  
Reply Like