RCU Forums - View Single Post - Control Throws Adjustment
Thread: Control Throws Adjustment
View Single Post
Old 08-27-2012 | 01:53 PM
  #12  
QSR1
Junior Member
 
Joined: Aug 2011
Posts: 17
Likes: 0
Received 0 Likes on 0 Posts
From: Pleasant Hill, IA
Default RE: Control Throws Adjustment
I have a Dynam TurboJet
I dont like the throw amount after build on the elevator, I just dont think its enough

12-15mm is what they say, I might have half that.

It is set on inner hole on servo control arm and outer hole on elevator control arm.

Control arm on servo is centered.

Ideas?
QSR1 is offline  
Reply Like