ORIGINAL: ahamay

Got the TGY-306G installed into the tail on my new Tarot 450 PRO V2 FBL build this morning. Servo looks solid. It's nice and fast and SUPER loud.[img][/img] Would have been nice if it came with a round wheel servo horn as well but a bit of trimming on the standard horn sorted that.

I've got some wiring to tidy up and some final pitch settings to check and it's ready for a maiden hopefully on Sunday. If anyone is interested in the specs for this build it's got the following config:

Tarot 450 PRO V2 FBL barebones kit from oomodel
ZYX v1 (not running 3.5 firmware)
Hitec HS-5065MG on cyclic
TGY-306G on the tail
Spektrum AR6115e rx
Turnigy H2218 Motor with 13T pinion (This is the red motor with the silver can, 3550kv)
Turnigy Plush 40amp ESC
CF Blades Standard in the kit
Nano-Tech 2200mah 3S 35-70c

Really looking forward to flying this one. If it's a screamer i'll drop a 13t pinion into my other 450 PRO as well.

Looks like a "getter"!

My mcpx has been out of action for months and I have some parts arriving today to freshen it up. I think when they get to a point when they need major repairs and lots of parts replaced it's better just to buy a new one.

I disagree!!

Hope everyone gets some flying in this weekend.

Jonesy