Ok

For the record. I am not selling these and I do sell a product that is in direct competition with the Clark board. I have tried to be as objective as I could when reviewing this product, and I hope I have at least helped out a little in this. As I have uncovered a couple of little issues I think I have to step away from this review process, as my comments might be taken the wrong way.

I think it is important that I tell you that this is not plug and play and my experience has been that you need to heat up the soldering iron, and do a little reading. Again I believe this is an objective observation.

If you buy one of these you will need to communicate with Clark directly for any guidance and help. I of course don't mind helping a little, but I will not spend too much time trouble shooting any problems with this hardware.

I like the DBC3/Benedini combo and that I support fully.

Cheers