ORIGINAL: YHR
Ok
For the record. I am not selling these and I do sell a product that is in direct competition with the Clark board. I have tried to be as objective as I could when reviewing this product, and I hope I have at least helped out a little in this. As I have uncovered a couple of little issues I think I have to step away from this review process, as my comments might be taken the wrong way.
I think it is important that I tell you that this is not plug and play and my experience has been that you need to heat up the soldering iron, and do a little reading. Again I beleive this is an objective observation.
If you buy one of these you will need to communicate with Clark directly for any guidance and help. I of course don't mind helping a little, but I will not spend too much time trouble shooting any problems with this hardware.
I like the DBC3/Benedini combo and that I support fully.
Cheers
Yes, I understand that.....its funny, over on rcregument site, some of the people were saying that this was a plug and play unit, when I when I told them the same things you are saying....I was warned for being a troll.....I ordered 2 with the hope that this will all get sorted out and some better instruction turn up. What this board is supose todo is just what I am looking for, I want to run a mix of hinglong and tamiya parts, I want tamiya recoil and I want better sound, I want hl turret rotation and gun elevation, I also want to run tamiya apples....If I can not figure it out, well, thatsa cunk of cashdown the drain, sucks to be me. If I can get it figured out, well then Isaved a bunch of moneyover just buying full tamiya systems.