RCU Forums - View Single Post - Hex Servo Screws
View Single Post
Old 09-24-2012 | 03:47 AM
  #25  
ModellbauUK's Avatar
ModellbauUK
 
Joined: May 2011
Posts: 740
Likes: 0
Received 0 Likes on 0 Posts
From: AltonHAMPSHIRE, UNITED KINGDOM
Default RE: Hex Servo Screws

I agree Dominic

All ask for was for a supplier of hex self tapping screws.

A simple "Yes you can get them from ............." would have done.

Plus a few very long in the tooth digs thrown in for good measure.

Ian
ORIGINAL: DominicM

If only all RCU jet forum threads were as entertaining as this one. Haven't laughed so hard in ages. Gimme 5 minutes. I'm just going to check relative supplier pricing of cable ties.