RCU Forums - View Single Post - Bobcat elevator servos
Thread: Bobcat elevator servos
View Single Post
Old 09-10-2003 | 11:15 AM
  #146  
Doug Cronkhite
My Feedback: (34)
 
Joined: Dec 2001
Posts: 3,821
Likes: 0
Received 11 Likes on 8 Posts
From: San Diego, CA
Default RE: Bobcat elevator servos
OK Guys.. I need some measurements made..

Length of the servo arm from the center of the output shaft (I think this is .4")
Length of the control horn from the hinge line (NOT the surface of the elevator).
Length of the pushrod itself.

Thanks..
Doug Cronkhite is offline  
Reply Like