RCU Forums - View Single Post - All Composite 1/7th P-40E Mould Build
Thread
:
All Composite 1/7th P-40E Mould Build
View Single Post
10-16-2012, 09:32 PM
#
449
Slow Low
Senior Member
Join Date: Apr 2007
Location: Toronto, ON, CANADA
Posts: 757
Likes: 0
Received 0 Likes on 0 Posts
RE: All Composite 1/7th P-40E Mould Build
no point in throwing another $100 in epoxy and cloth at reinforcing this section until I've seen the cavity - if all turns out well, I can always rough it up with a cup wheel on the grinder and lay down a few more layers of heavy cloth
hopefully this will set up enough to remove the forms tomorrow - now we wait....lol
Reply
Like
Slow Low
View Public Profile
Send a private message to Slow Low
Find More Posts by Slow Low
View iTrader Profile