On to the covering. I'd like to thank RFCafe on YouTube for the video Covering Compound Curved Surface with Monokote.

I started with the bottom surface of the starboard wing. I measured the wing, adding 3" to the length and 1-1/2" inches to the width. I have a 3' steel ruler which was very useful.



I won't go into a lot of detail about the covering except to say that I've never covered a wing or a compound curve before. I made a few mistakes but overall I'm pleased with how it turned out.







I learned a few things along the way so I'm confident that the results will improve as I continue. Incidentally, the base covering is white but I'll be adding some sort of custom scheme that will clearly differentiate the top and bottom surfaces.