RE: Bootlegger redux...
So, as of today I'm ready to paint, everything's rigged and functioning. It's 8 lbs. 2 oz. as it sit on the wheels, there's lots of primer to sand off the wing and tail, weight should stay close to 8.5 lbs. And, the CG's pretty close too.
I will start painting after the holidays, if my paint's still good and I get a new compressor. The one I've had since I built my original Bootlegger is on it's last legs... after it's second tank...
Bootlegger redux is rigged with this stuff:
OPS Speed .60 'Big Red' F.I.R.E. with OPS pipe and header (sorta 'homemade')
Futaba 18MZ
Futaba R617FS FASST receiver
3) Futaba 9151 servos, 1) Futaba 3016 servo, 1) Futaba 3170G servos
Futaba PS-10 regulator and 'big' switch
Dave Brown Southern Pro retracts and Lite Flight wheels
Sullivan 16oz. slant front tank
Sullivan 'gold' cable for throttle and nose wheel steering
Dave Brown F'glass arrowshaft pushrods for elevator and rudder
Assorted clevises and servo connectors
Check out the attached pictures...
Regards, and Merry Christmas!
Cliff