RCU Forums - View Single Post - How should hinge points be setup?
Thread: How should hinge points be setup?
View Single Post
Old 01-15-2013 | 08:43 PM
  #7  
sensei's Avatar
sensei
 
Joined: Jul 2002
Posts: 2,829
Received 17 Likes on 15 Posts
From: SAN ANTONIO, TX
Default RE: How should hinge points be setup?

ORIGINAL: Gray Beard

First photo and I either bevel the area in the TE and LE so there is only a small gap between the control surface. I use a small counter sink to get the bevel or I just cut a notch.
+1

Bob
sensei is offline  
Reply Like