I give up...
I'm programming my new 12Z on an aerobatic model. I have been through the manual a half-dozen times, and through the radio menus a dozen times.
I CANNOT find anything relating to control surface exponential. I want to slow down the response, from center, of the ailerons and elevators, softening the controls, as it were. I'm sure its staring me in the face, perhaps under a different name (servo speed?).
In the AFR/Dual Rate menu, there is an EXP1 and EXP2 mode, but when I set that, every time I touch either the joy stick or wheel/enter button, it goes back to LINEAR.
I'm really at my wit's end here; what am I missing?
.