RCU Forums - View Single Post - Cut cooling slots in CF Spinner
Thread: Cut cooling slots in CF Spinner
View Single Post
Old 03-04-2013 | 07:52 PM
  #2  
Jetdesign's Avatar
Jetdesign
My Feedback: (8)
 
Joined: May 2008
Posts: 7,056
Received 0 Likes on 0 Posts
From: Honolulu, HI
Default RE: Cut cooling slots in CF Spinner
Here are two examples:

http://www.f3aunlimited.com/webstore...roducts_id=693
http://www.f3aunlimited.com/webstore...roducts_id=659

I would measure and mark, cut with a dremel cut-off wheel, and finish by hand with sandpaper, probably glued to a small dowel. Then balance.
Jetdesign is offline  
Reply Like