RCU Forums - View Single Post - Cut cooling slots in CF Spinner
Thread: Cut cooling slots in CF Spinner
View Single Post
Old 03-09-2013 | 06:12 AM
  #10  
crashlander
My Feedback: (10)
 
Joined: Apr 2002
Posts: 397
Likes: 0
Received 0 Likes on 0 Posts
From: Orlando, FL
Default RE: Cut cooling slots in CF Spinner
I have been balancing both the backplate and spinner separately. However, I believe they should be balanced as a unit. The problem is if you have to change props, -start all over again?

Orlando
crashlander is offline  
Reply Like