I've been a fan of Dynamite tools, but in all candor am beginning to wonder if their lineup of hex drivers can handle the amount of wrenching I do. Below is a pic of four different sets I've gone through in the past 12 months. These are the 2mm drivers. Every size greater has held up much better - 2mm being the most common so it gets the most work. I tried switching tips when I could, but eventually the set screw gets stripped. ;-)

I'm looking to get a real quality set instead of switching out every few months. I hear a lot of good things about MIP. I ordered an MIP Thorp 2mm driver to test it out. Any other suggestions? Thanks





</p>