[size=3]
I have been waiting ten months for a set of custom headers from Mintor for my 110. They finally arrived yesterday. I ordered the originals from TopDawg and there was no way they would fit my 35% Dalton Extra 260 not enough drop and way too long with no way for the front exhaust to drop. Both Mintor and TopDawg state that the header must be a given length. Well the new custom headers have enough drop but the length factor is again too long. I just cannot wait another ten months or longer for another attempt at getting it right. So can someone advise me as what the downside of cutting 27mm off of the new headers would be.