Hi Steve,

I had in mind in using either the MOKI 30cc gas engine with rear induction, rear exhaust (or sideways) or the MVVS 30cc gas too or the Tonini 25cc (german gas engine).
I wish to keep on the lighter side of this if possible. I also have in mind in using the MICK REEVES fiberglass covering instead of the traditional balsa/fiberglass system but still have to find out how much I need.
Its no problem in putting up a few shots of the fiberglass fuse...getting out doing it is the problem! heheheh

Steve...have you got any documentation regarding the FS number of the light grey that was used on the underside by any chance? I got my color scheme from a book about the DC-3 I have of the real DC-3 Canadian Airforce. Another scheme I like is the OTIS SPUNKMEIER scheme but unfortunately I dont know which type of fonts they use in their wording.

Catch you later.

Reuben