RCU Forums - View Single Post - Servo programmer issues
Thread: Servo programmer issues
View Single Post
Old 05-02-2013 | 04:25 AM
  #9  
grosbeak's Avatar
grosbeak
Senior Member
 
Joined: Dec 2010
Posts: 1,321
Likes: 0
Received 2 Likes on 2 Posts
From: Ottawa, ON, CANADA
Default RE: Servo programmer issues
What eventually worked for me was the following:

1. Plug in USB cable
2. Plug in battery
3. Start software
4. Plug in servo

However, the last time I programed the servo the programming didn't "take". It reverted to default when I plugged it back into the receiver. Argh!
grosbeak is offline  
Reply Like