RCU Forums - View Single Post - Help covering concave surfaces
Thread: Help covering concave surfaces
View Single Post
Old 05-13-2013 | 05:36 PM
  #4  
Top_Gunn
My Feedback: (6)
 
Joined: Jun 2005
Posts: 2,344
Received 6 Likes on 5 Posts
From: Granger, IN
Default RE: Help covering concave surfaces
Cover the bottom. Iron the covering to the ribs, but don't shrink it tight. Run a bead of thin CyA along the bottom of each rib. Then finish up as usual.
Top_Gunn is offline  
Reply Like