ORIGINAL: wojtek
ORIGINAL: mr_matt
This was the one to get when it was going to be about 2300, it went up to 3300, lets see where the price ends up.
http://formlabs.com/
Matt,
It still leaves ''steps'' . I looked at it also, and have seen samples first hand of the output. I will have to look it up, but there are other printers that have similar specs and also work via light cure that are around 1/2 price .. I will post the link when i'm back on my other computer.. they are all pretty slow also still .. From what i have seen of the market, its best to wait another 1 year or so... the tech and pricing can catch up .. many ( most) of these 3d printing companies are just beginning to launch out of their VC funds .. the market has a lot of room for rapid growth and improvement.
Voy
I think this is VERY good advice and I plan on following it.