RCU Forums - View Single Post - Starting out in RC again
View Single Post
Old 06-07-2013 | 07:35 PM
  #16  
mmabc
Member
My Feedback: (1)
 
Joined: Jun 2013
Posts: 34
Likes: 0
Received 0 Likes on 0 Posts
From: Pearland , TX
Default RE: Starting out in RC again

I said it was a sad state of affairs. I went up into the garage rafters and was looking at some of my old stuff. I was bummed out that the Dalotel had half the rear stabilizer broken off. I think I know where the other piece is. I don't remember how it happened. Probably broke it during a move or bad handling or something. I wonder how hard that would be to repair? Pretty disappointed!

The trainer is pretty messed up too. I think it crashed, but funny that I can't remember. The fuse near the tail is busted up all around near the last bulkhead.

I was also looking around and I have a Conquest IVInever finished. All the flight surfaces were built. I think I got a little overwhelmed about figuring out the engine and electronics installation, and then I started losing interest.

I guess I still have the stickI can get flying pretty quick! Now I'm wondering if I even want to mess with this old stuff. Maybe the Dalotel. That was a pretty cool plane.