I have a 8uaf that has a servo hooked up to chn 8 as a trigger for a camera. Was working fine untill today. I linked- chn8-chn8, then linked to switch f in the down position. There was no ofset or anything I changed. The switch would read "on" or "off", wasnt set to inh. I now adjusted the ofset and had to reverse the servo. It works now but Im worried there may be problems in the future, on inportant chanels. Has anyone experenced "glitchs" or strandge malfuctions in linking certain functions to switches on the 8uaf? Thanks for any help, this is very important as I could loose control of my model.