No real progress since the last post. I did get the wing mounting blocks in the lower wing both front and rear and also got it sanded down and ready for the top sheeting.
I'm struggling a bit trying to figure out my motor, esc, battery combo, and a couple guys in the club who are super knowledgeable are helping, but I've been a bit tied up so we haven't completed that process yet. What setup did you find will work for your motor, esc, battery combo.
I also constructed the fin and rudder per plan, nothing earth shattering there.
I have all the ribs cut for the upper wing and ready to go, but I'm waiting to start construction of the upper wing until I have the lower wing completed and I know it all went together.
Before sheeting the final part of the lower wing I want to check the incidence and again double check that all my drawings and cuts are correct. Hoping to get over to a friends shop to do that this weekend.