I've been looking at arfs they carry for a while now and finally ordered one last October. Because of some medical emergencies & problems in the family I didn't get around to starting on it til this last week. I went to put the elevator halves on the Skyline 70 60" Sbach 342 and found out they DON'T MATCH! It looks like they took a left side half, flipped it over, then covered it like it belonged to the right side (or vise-versa). I got caught up cutting slots for a joiner wire because no method was supplied to join the halves and when I got to final assembly, OUCH, the right elevator was LOWER than the left. I should have checked it before I actually began the joining. when you look at the ELE halves from the inside edge, the leading edge on top is longer than the edge to the bottom on the left ELE, the opposite on the right ELE. WEIRD. I sent them an e-mail just a few minutes ago, so we'll see what happens. The rest of the arf looks just like the ARFMFGR version I owned before. Not a positive experience so far.