Gerry is a master craftsman and his work reflects that. I will pass on your compliments. The vertical fin is not all the way forward in the picture with the ply support in place. and was held back slightly from it's proper position for the photo to show the ply joiner on the fin rear and the recess in the lower fin support. The picture before that shows the tracing of the recess to be cut and in that picture the fin is in it's proper, full forward position. The fin will be moved forward into it's proper position and the ply joiners (front and rear) will mate perfectly with their corresponding recesses.
Last edited by chistech; 03-10-2014 at 08:19 AM.