Originally Posted by
1QwkSport2.5r
I don't bother with "the other forum".
I'll recant my request as it was not realistic.
WOW! that didn't take long....(Smiles)
Quote:
I noticed on the site, RCU, moderated by the technically inept, that you are asking
that poor feckless fool to pull the head off his engine.
Perhaps I can shed some light on the subject. The engine he has is an early Eagle IV. As such the head is most likely the one I showed you earlier. That is it has a very large flat squish band with the dome formed by a 5/8 full radius (ball mill) cutter. Do you want a set of drawing to copy this configuration? This head is not as bad as the earlier but similarly shaped head found on the Eagle III with its 1/2" full radius (ball mill) cutter. End Quote....
Tell him that we're all happy for him.