Finally got my Punch Software ViaCAD 2D/3D and have to say it is a good package. It took a few hours of playing with it, but I just printed a perfect 1-to-1 page of an engine back plate I need to machine. I am just using it in 2D mode at the moment but I can see that in not too much time I can transition to 3D. Right now I just need to print out drawings I create. Also did some long fuselage drawings and will have to figure out how to get them into pdf or other format to bring to a print shop. Doing A and B size prints on my connected printer so far is no problem. I have a Mac so my choices were a bit limited but after trying out a few other solutions, I think I have one that I can use easily.