RCU Forums - View Single Post - BIG LAMA
Thread: BIG LAMA
View Single Post
Old 06-22-2014, 04:57 PM
  #6669  
texasbragg
Junior Member
 
Join Date: Apr 2014
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Default
Not sure if anybody will read this but here goes. Going boardless and brushless on my BOL I have a E-Flite Head Locking Gyro and a DD Co Axial Mixer 2 30 amp Dynsm ESCs and using ESky Brushless Motors. My problem is I have not power on the pot side of the Mixer. I can switch plugs on the mixer and the each motors will run on the other side of the pot. Any ideas.

Thanks
Al
texasbragg is offline  
Reply Like