Originally Posted by
rczippy
I hope to finish sheeting the fuse this week then time to finish the top of the wings. Before i get there i could use some input.
I would really like to make the ailerons controlled by an RDS system. I was going to get all components from
http://www.irfmachineworks.com/g2rds/
Can anyone comment on if this a good idea or bad idea? Also what would you think the servo requirements would be? I think the RDS would look great since the rest of the linkages are already hidden.
It will ( would ) be very interesting to read postings ( comments ) by anyone who has used the system.
The aileron drag equalization setup, if any, would also be most interesting.
I am following this thread with great attention.
Zor