Firstly hello!

I was a member on another Helicopter forum but things seem very quiet in comparison to here!

Anyway, I was given the above helicopter for Christmas its hard to fly but its enjoyable (just about good enough to hover now) Ive had plenty of crashes but repairing it is teaching me more about it

Anyway so far Ive managed to go through several rotor heads and plenty of ring like push rods and a flybar to top it off.

However, I had a rougher than normal landing on Friday and i never noticed that the tail fin had snapped and caught the tail rotor. Tried to start her up again and put a bit of power on before i noticed the problem. Unfortunately, by that point it was too late. the motor was red hot and it no longer works.

So I'm assuming I need a new tail motor (no problem as I need a new fin too this is a good opportunity to upgrade to the cp3 tail.

But how do I know if I have damaged the 4 in 1?

Cheers everyone!