OK here is how I set it up. A=Ail. w/ Y harness 3 wire power lead/ Ail port rx.
B= Rt. Elev. 3 wire power lead/ Elev. port rx.
C= Lf. Elev. Orange/ Aux 4 port rx.
D= Rud. Yellow/ Rud. port rx.
E= Nws. Green/ Aux 3 port rx.

All controls are setup and working! Next will use the computer and turn off aux 3 that goes from rx to Cortex that controls nws. Not very familiar with computer program? Will plugging in usb to jumper port erase programming in Cortex? Well...... will find out and advise if successful turning off stabilization on nws in up position. Guess the worst that can happen is blow the plane up ha ha!