RCU Forums - View Single Post - Eletronic engine syncronizer **SUPPORT **
Thread: Eletronic engine syncronizer **SUPPORT **
View Single Post
Old 02-20-2015, 05:36 AM
  #1008  
Rocketman_
 
Rocketman_'s Avatar
 
Join Date: Oct 2003
Location: , MA
Posts: 1,270
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by kiwibandit
Hey Dgiatr,
Originally, I had my sync point set at 2500 revs. I changed this to 3500 revs. Now when it pulls the power back it will stop at the sycn point and hold there. This power setting will still allow me to land with power and have the sync engaged. I have done 10 flights with these new settings and it is all working flawlessly.
I think I may be misinterpreting the above butit sounds like the "throttle creeping" still persists but is nowlimited to a low point of 3500 RPM.

Originally Posted by kiwibandit
Hey Dgiatr,
I know others have said in earlier posts that 3004 servos will be fine but it would appear that more powerful servos will ensure that it all works properly.
Is there an explanation as to why throttleservos have to be very, very powerful? Four times more powerful than the S3004? Does Down & Locked know about this?
Rocketman_ is offline  
Reply Like