RCU Forums - View Single Post - Building technique: Utilizing a Wing-Jig, Scale P-51 "Speed Wing"
Thread
:
Building technique: Utilizing a Wing-Jig, Scale P-51 "Speed Wing"
View Single Post
02-28-2015, 12:06 AM
#
5
Iron Dog
Join Date: Feb 2009
Location: Sacramento, CA
Posts: 1,348
Likes: 0
Received 3 Likes on
3 Posts
Make some decisions regarding strength
vs.
weight, cost, and preferred construction methods:
Will both carbon rods be used, and glued permanently within the structure of the wing?
Will the drill rod(s) that come with the wing jig be used during construction, and slid out after sheeting the wing?
If so, be very careful not to get any glue on the drill rods. Otherwise, when removing the drill rod, ribs may be split/damaged when drops of hardened glue are forced through the holes that have no additional clearance for this increased mass that must pass through.
Reply
Like
Iron Dog
View Public Profile
Send a private message to Iron Dog
Visit Iron Dog's homepage!
Find More Posts by Iron Dog
View iTrader Profile