Programming Ch. 6 Futaba T7C Trying to get full travel
I'm trying to program ch. 6 for float retracts. I have it configured on P-Mix1 using Switch E.
My problem is I'm only getting half the travel even though I am setting it up at 100%. I am going to need full travel to get the rudders all the way up.
Ch. 7 is set up for flaps with switch G. Position 1 flaps up, position 2 for take off, position 3 for landing. And Ch.1 and 5 are ailerons. I have the battery and my rudder retract servo on Ch. 6
Thanks
Last edited by vindee; 03-11-2015 at 07:57 AM.