Originally Posted by
tyor
It sounds great. Do you have a 1/2 inch travel up and 1/2 inch down or is that total travel?
I have cut out in the wing for the retract mounts. I used a angel grinder to get clean cuts
I actually have 1/2 inch up and down, with dual rates, that is cut to about 3/8 up and down. The elevator is VERY effective. Looking forward to you final product.
In case it can be of some help, here is my build thread:
http://www.rcuniverse.com/forum/rc-w...ov-i-16-a.html
Here was the crash video just for fun. There was actually no structural damage, outside of a broken stab spar. Long story on cause of the crash, but not the airplane's fault
https://www.youtube.com/watch?v=5CYDUqhwMMg
JQ