All the molds have been prepped with the frekote mold release and all but the spinner mold had a coat of primer put in.
While the primer dried, i finished the horizontal stabs by adding the 1/2" TE piece for the hinge gap covers, then capped all of the areas thst would be exposed after glassing with .010 and .005" G-10.
Then they were glassed and peel ply applied (no photo).
I also did all of this stuff:
Cowl:
Supercharger scoop:
Canopy and gun hood:
I have to be up at 4am for work, so ill pull some peel ply and pop the gun hood out and post up a photo in the AM.