I think the answer was no last time it was asked somewhere but here it goes again in case there's a new kid on the block, does anyone make a 1:4.4 scale cockpit for the CARF Mustang that is prepainted and mostly assembled like the 1/5 scale
http://www.iflytailies.com/ one? I haven't seen a CARF in person with one installed but the pics I see somehow make the cockpit and pilot figure seem a tad undersized.
With the tallies cockpit, do the legs general fit or are they usually removed?
Also, these two pilot figures look they should both work. What is the 'normal' way to secure them in their seat yet be removable? Velcro on their butt? Actual working 'seat belt'? No doubt multiple ways but I've always just glued them in before but not this time.
http://www.iflytailies.com/store/pil...-scale-pilots/
http://www.warbirdpilots.com/RC_Pilo...-1-4-figur.htm