RCU Forums - View Single Post - Xicoy CG machine delivery update.
Thread: Xicoy CG machine delivery update.
View Single Post
Old 04-28-2015 | 05:34 AM
  #18  
Len's Avatar
Len
My Feedback: (3)
 
Joined: Feb 2002
Posts: 345
Received 0 Likes on 0 Posts
From: Winnipeg, MB. Canada
Default
Hi Oli, David,
I have ordered the Angle sensor upgrade (from you by the way order #1083) and was just going to dnld the software in advance of receiving them. I upgraded the unit from 1.0 to 1.1 without a hitch, but I do agree flashing the eeprom is a mildly hazardous affair. I likely won't install 1.3 until I have the sensors here. By the way, I love the 3D printed cones for the CG machine! The unit was a big hit at the local club's 'show and tell' the other night! Any hint as to when the sensors might ship?
Thanks again for all you do!
Len
Len is offline  
Reply Like