Hi Oli, David,
I have ordered the Angle sensor upgrade (from you by the way order #1083) and was just going to dnld the software in advance of receiving them. I upgraded the unit from 1.0 to 1.1 without a hitch, but I do agree flashing the eeprom is a mildly hazardous affair. I likely won't install 1.3 until I have the sensors here. By the way, I love the 3D printed cones for the CG machine! The unit was a big hit at the local club's 'show and tell' the other night! Any hint as to when the sensors might ship?
Thanks again for all you do!
Len
Hello Len.
Woody is just back from Mississippi Afterburner.
The angle sensor kit is packed and ready to go to you. It will go today or tomorrow...