RCU Forums - View Single Post - Question about K&B mufflers

07-31-2015 | 05:58 AM

#7

gcb

Joined: Oct 2002

Posts: 3,440

Likes: 0

Received 4 Likes on 4 Posts

From: Port Ewen, NY

Quote:

Originally Posted by Bob Jablonski

I was Talking to them just yesterday. They are tweaking the needle valve for a couple special runs of motors for me (still a couple 2-4 weeks out). I don't see why they couldn't have some with carbs put on them. They already have a .18 with a carb for RC cars biggest thing is change the head from the heat sink to a airplane head. or if they are interchangable take the RC car carb and put it on the K&B .18 CL engine.
Mr. Bob
Countyline Hobbies
Grovertown, IN.
574-540-1123
[email protected]
[email protected]
Like us on Facebook

Bob,
Just a guess but I think car engines run at a much higher RPM than most aircraft engines used for stunt or sport. That carb would probably need to be run with a bladder tank because of insufficient fuel draw.
Good luck with your new engines.

George

Reply Like