RCU Forums - View Single Post - Does anyone do 3D printing?
View Single Post
Old 08-25-2015 | 02:29 PM
  #17  
Jhdumas
 
Joined: Nov 2011
Posts: 268
Likes: 0
Received 0 Likes on 0 Posts
From: Barboursville , VA
Default

Hey Rich... this is what I know... first the gun-side door was phased out ....first it was simply welded shut.. then removed completely.. and finally a vision port... the last 2 steps could be inverted... but it's much like I stated... as for the Lee Cupola... if Woz is not doing a Grant turret.... I would also

like a Lee Commanders Cupola.. the Lee conversion that I purchased from that Hungarian.. is a Burmese or Indian Lee... later version.. that is why is is missing the gun-side door and the Cupola and has that longer 75mm cannon

I am hoping he will do a Grant Turret as I want to do an RC Grant.. The M3 Suspension conversion is absolutely a must and would like to get it... I have not heard from him so I do not know if I can get it or not... so it is all dependent on Woz at this point... I would also liker to purchase his

Firefly Turret Radio box and possibly the Small-hatch M4a1 conversion kit... but that is just my wish list.. I need to know cost first...

Last edited by Jhdumas; 08-26-2015 at 02:11 AM.