I think if you cut the side of the elev servo arm off that not being used and then straighten out the rudder cotrol rod it would be better . When setting it up i would have switched the servos from rudder now to the throttle servo now so your rudder control arm was close to the fuse on that side . . There are a number of ways to run control rods, but try to get them running as straight as you can with out any bends. BTW to the MODS here . Above this post i just made is advertising for a drone . Advertising is all over the internet and now in the forums on drones and to me all they do now is bring bad news to our fun hobby and unwanted attention to us guys who dont fly our rc planes in full size aircraft airspace and follow AMA rules ,in my case for 30 + years . joe