RCU Forums - View Single Post - High Flow fuel systems
Thread: High Flow fuel systems
View Single Post
Old 01-10-2016 | 12:16 AM
  #36  
olnico's Avatar
olnico
 
Joined: May 2007
Posts: 4,120
Likes: 0
Received 16 Likes on 10 Posts
From: Houston, Texas.
Default
Originally Posted by FenderBean
it may just be me but I feel the biggest mistake people make is not using large enough fittings on the Vent side of the system. The fuel pressure from pulling fuel through system really grows when you restrict how much air you can pull into the tank. If the fuel leaving the tank is overcoming the the ability to pull air in things start to go bad.
Well, I think that you will like my new design:

http://www.ultimate-jets.net/collect...vent-fitting-1

It is accepting 1/4" tygon tubes directly!
The tubes are available in our fuel hardware section as well:

http://www.ultimate-jets.net/collect...ardware?page=1

I believe that I have the most comprehensive and best priced selection of High Flow and Ultra High Flow accessories on the market. This is because all of this is in-house and custom designed and CNC produced!
I needed a complete range of professional fuel system hardware for our UAV operations. Since I could not find what I wanted on the market, I decided to make it myself!
Thus the purchase of the Siemens Sinumerik CNC lathe and CNC milling centers...
Last edited by olnico; 01-10-2016 at 12:19 AM.
olnico is offline  
Reply Like