RCU Forums - View Single Post - What hex drivers do you use?
Thread: What hex drivers do you use?
View Single Post
Old 02-22-2016 | 06:21 PM
  #6  
DieHarder's Avatar
DieHarder
 
Joined: Jul 2012
Posts: 2,984
Likes: 0
Received 0 Likes on 0 Posts
From: Grand Haven, MI
Default
I bought both the metric and SAE (Evader takes 3/32" ) sets back in like 2012. Been using the same sets since and have only broken the 1.5mm once and the 0.05" three times (sucks so much that the replacement shaft is like an inch shorter than the original ). Great set though at only $40 for all six common sizes!
Originally Posted by collector1231
I'm not a huge fan of those Ti-Nitride coated ones. They seem to break a lot easier in my experience. As far as I go for hex drivers, its machined Dynamite Reds or nothing! Lol. You will most likely never need another hex driver in your life.

http://www.motionrc.com/dynamite-mac...FUM8gQodRacHmA
DieHarder is offline  
Reply Like