Originally Posted by
myersflyers
Jetmodeler,
Thanks for the photos and updates. Keep them coming. Appreciate the servo size references. Hope to getting building mine next month. I realize you're building as time permits, but are you keeping track of your build time?
Keith
The servos used in the prototype are listed in post #121 of this thread and were based on torque values at 6V.
[h=2]
Hi-Tec Servo list[/h]
- Ailerons: (2) HS-7985MG
- Elevator: (2) HS-7955TG
- Flaps: (2) HS-7955TG
- Air Brake: (1) HS-7955TG
- Rudder: (1) HS-7955TG
- Nose Steering: (1) HS-645MG or HS-5645MG
- Nose Gear Door: (1) HS-645MG or HS-5645MG
- Mechanical Retract Valve: (1) HS-225 (MG) or Electronic Pneumatic Dual Action Valve
- Mechanical Brake Valve: (1) HS-225 (MG) or Electronic Pneumatic Single Action Valve
Jr Servo List - Ailerons: (2) DS8411
- Elevator: (2) DS8611A or DS8711
- Flaps (2) DS8611A or DS8711
- Air Brake (1) DS8611A or DS8711
- Rudder: (1) DS8611A or DS8711
- Nose Steering: (1) 4721
- Nose Gear Door (1) 4721
- Mechanical Retract Valve: (1) 351 or Electronic Pneumatic Dual Action Valve
- Mechanical Brake Valve: (1) 351 or Electronic Pneumatic Single Action Valve